Appearance and packaging
Material / board thickness: aluminum / 1 mm |
Length × Width (mm): 260 × 540 |
Weight (gr): 195 |
Attributes
Attributes
Protection against: short circuit, over temperature, overload and overload
Performance is guaranteed in combination with Radnour and TCI drivers
It has a 3-year warranty (read the warranty conditions.)
Aluminum board with high thermal conductivity of 1.5 W/m.°K
Produced under the technical supervision of TCI Italy
With push connectors for ease of installation
Ability to protect against surge voltage up to 2000 volts
compatible with dimming drivers
Rated life more than 50,000 hours
High quality electronic components
Light output up to 120 lumens/watt
High luminous flux retention factor
Uniform light distribution
benefits
Reduced replacement costs with a lifespan of over 50,000 hours
Energy saving of more than 85% in electricity consumption
No ultraviolet and infrared rays
Reducing greenhouse gas emissions
Compatible with human health
environment lover
Application and terms of use
Application
Performance is guaranteed in combination with Radnour and TCI drivers
Interior spaces
Terms of use and safety
If the LED modules are wired in parallel, if one of the modules fails, the current of the other modules will increase and cause damage to the remaining modules.
Static electricity or voltage surges can damage the LED module. Therefore, use anti-ESD wristbands or gloves when working with the LED module.
Avoid contact of any liquids with the module. It is recommended to use isopropyl alcohol (IPA) to clean the module.
Avoid touching the product when it is on or shortly after it is turned off due to high heat.
Use cap screws with a plastic washer to prevent any damage to the module.
Due to its very low energy consumption, it is compatible with solar lighting systems.
Before installing, changing or touching the product, cut off the power.
Make sure that the temperature of the module does not reach the maximum specified value.
Do not apply mechanical shocks to the isolated module.
It is recommended to use all the screws to fix the module.
Permissible temperature range of the application environment: -20 to 50 degrees Celsius.
Do not expose the module to dust and high humidity.
Do not use in places where water may fall.